Dimplex BLF50 Owner's Manual page 14

Fireplace Installation
Figure 10
• Plug in (you may run the power
cord out of the framed wall
opening to an existing outlet
or install an outlet on a nearby
wall stud within the wall).
WARNING: Do not attempt to
wire your own new outlets or
circuits. To reduce the risk of
fire, electric shock or injury to
persons, always use a licensed
electrician.
Ensure that the Main On/Off
Switch is set to the Off position
(refer to Operation section)
and that the circuit on which
the fireplace is to be installed
14
2 x 4 Framing
has the power cut off at the
service panel until installation is
complete.
• Hard wire the fireplace
(recommended). Follow the
hard wiring instructions on
page 9.
Lift fireplace and insert into
opening (Figure 11).
Figure 11
Mounting
holes
Use bubble level (supplied)
to level the fireplace within the
framing. Adjust as required.
Drive four (4) supplied
mounting screws through the
four (4) mounting holes located
www.dimplex.com