Table of Contents
Advertisement
NOTE: Once
Func
numeric entry until 2 digits have been entered or until 5 seconds of inactivity have elapsed.
Use of the
Func
Section 3. For example, press
a channel.
OSD*
OSD (On-screen display)
Press and hold
invisible). Or press
direction (useful if you are unsure of the present status). Note that invisible menus are fully
functional.
NOTES: 1) With OSD on, you can still mute menus, error messages, slidebars, etc. with the
appropriate setting in the Preferences menu. 2) The status of the
LCD window on the rear panel of the projector.
Help
Help
Press
for detailed information about any current menu and highlight. Press
Help
exit. Press
Help
Keypad, Channel Selection and Status LEDs. Press
Test
Test
Test
Press
to display one of the available test patterns. Press
available pattern in the sequence.
to remove the current test pattern from the screen and return to the current external source.
NOTE: For a complete list of all test patterns, see the Advanced menu description later in
Section 3.
Keypad operating settings (protocols)
The remote keypad and the optional wired keypad both store keypad operating settings (called
protocols) in memory. In some advanced applications, such as when you want to use two sepa-
rate keypads to control two projectors independently, you may want to override the original
protocol set at manufacture (which is "A or B") for one of the keypads. See section 2.10,
Keypad Protocols and Conversion for complete instructions.
Func
6
Func
6
Func
6
Func
6
Func
6
Func
6
Func
6
is pressed (with no OSD present), the projector will not respond to non-
key within the menu system is noted with the appropriate topic elsewhere in
in the Channel Setup menu to enable deletion or copying of
Func
OSD*
for approximately 1 second to toggle menus on or off (i.e., visible or
followed immediately by
OSD*
to access the General Help menu consisting of Using Help, Projector Setup,
Test
= Red
1
= Green
2
= Blue
3
= Red and Green
4
= Green and Blue
5
= Red and Blue
6
= All colors
7
ON
or
Exit
to leave General Help.
will exit after the last pattern, or press
3-9
OPERATION
to guarantee the correct toggle
OFF
key is displayed in the
OSD*
Help
Test
again to display the next
at any time
Exit
again to
Advertisement
Table of Contents
