Table of Contents
Advertisement
Input2
Input 2
Input2
Press
to select the source connected to INPUT 2 on the projector (an optional interface).
This is the same as entering
Input 3
Input3
Press
Input3
to select the source connected to INPUT 3 on the projector (composite video). This is
the same as entering
Input4
Input 4
Input4
Press
to select the source connected to INPUT 4 on the projector (S-Video). This is the same
as entering
Input
Input
Input
Press
Input
connected serially to the projector's switcher port. The first digit represents the number you have
assigned to your switcher (usually 1-9, or "0" for one of the four inputs on the projector). The sec-
ond digit represents the switcher's slot number (1-9). For example:
NOTES: 1) Although you don't need to use the input key, you can also use
input "slots" on the projector itself: use
switcher), then
nation with higher numbers is an invalid entry. 2) See 3.5, Using Channels and Inputs for a
detailed explanation of inputs.
Input
NOTE:
key behavior during a presentation depends on whether or not the Display Channel
List option is selected in the Preferences menu. You can choose to have on-screen feedback when
you press
Input
screen feedback. See Preferences later in this section.
Channel
Chan
Press
to select a specific source setup (channel) defined and stored in projector memory.
Chan
Once you enter a 2-digit channel number (or, if there is a list displayed, highlight it and press
), the display will automatically change and update according to the numerous setup param-
Enter
eters defined for that channel.
NOTE:
key behavior during a presentation depends on whether or not the Display Channel
Chan
List option is selected in the Preferences menu. You can choose to use a scrollable list of chan-
nels when you press
without on-screen feedback. See Preferences later in this section.
Stby*
Standby
Stby*
Press
and hold for approximately 1 second to blank all display and mute the audio output
while keeping the projector in a warmed-up and ready state. Or quickly press and release
and follow immediately by
are unsure of the present status). Note that the lamp and electronics remain ON in standby mode,
even though the image turns to black and most functions are disabled. To leave standby, press and
Input
0
.
Input
3
0
4
0
when you want to display from a specific source location, such as a switcher
Input
1
= display data from switcher 1, slot 2.
2
,
,
,or
as the second digit (the desired input slot number).
1
2
3
4
, or you may prefer to enter the desired source location "blind", i.e., without on-
Chan
, or you may prefer to enter the desired channel number "blind", i.e.,
ON
or
.
2
as the first digit (representing the projector as the
0
OFF
if you want to guarantee the correct toggle (useful if you
3-5
OPERATION
to access the four
Input
in combi-
Stby*
Advertisement
Table of Contents
