Getting Started - Runco Reflection VX-3c Owner's Operating Manual

Getting Started

To get started using your VHD Controller and projector, follow these simple steps:
1. Ensure all sources that you are using are properly connected to the VHD
Controller. This is something your Runco dealer has probably already done for
you; if not, please refer to the 'Connection Examples' and the owners manuals of
each appropriate source as necessary.
2. Turn on all sources. If a A/V receiver is being used to switch the video, ensure
that is also turned on.
3. Turn on the VHD Controller. Make sure the Main Power switch (pg. 6-6) is ON,
then press the power button on the front of the controller (or the power button on
the remote). Ensure the red LED lights up on the front of the unit.
4. Turn on the projector.
5. With the left or right buttons on the front panel or remote, select the desired
source. You may also do this by going through the menu (see pg. 6-12).
6. Select the desired aspect ratio by using the up and down buttons on the front
panel or the remote. You may also do this by going through the menu. For an
explanation of Aspect ratios, please refer to pg. 6-16.
6-10
QUICK SET-UP GUIDE