38
Optional Equipment
11 Use a T-20 torx wrench to remove the stock regulator (see picture below). This item may be
discarded.
12 The LP regulator has an installation sheet included with it – make sure to follow all of the directions.
Place the regulator on the gas control valve – MAKE SURE IT IS CORRECTLY ORIENTED. Secure
using the screws included with the motor – tighten to 25 Lb-inches. Leak test this area after
installation to verify proper installation.
13 Restore the appliance to the correct configuration. Make the gas line connection, bleed the gas line
(if applicable), start the heater and thoroughly leak-test all gas connections and the gas control valve.
© Travis Industries
(for qualified installers only)
4100322
100-01237_000