Installation (for qualified installers only)
3
The rheostat may be installed in either the control panel or on the surround panel (see illustration below). If
installing in the surround panel, use the included extension wires (extension wires not required if mounted in
control panel). Attach the rheostat wires to the wiring harness and secure to either the control panel or surround
panel. Make sure the wires do not contact any hot or moving parts.
NOTE: If you are installing the rheostat into the control panel, install the button plug
into the surround panel trim to conceal the circular hole (see the illustration
to the right).
On/Off Switch Installation
•
The on/off switch is bundled with the power cord on the outside of the insert. It is installed into the surround
panel trim for most installations. If you are using inside-fit panels or other configuration that does not use the
panel trim, install the on/off switch into the control panel. See below for installation details.
Upper Right of Trim
(preferred)
1 Disconnect the red and brown wires leading to the on/off switch.
2 Insert the wires through the rectangular mounting hole on the surround panel or control panel.
3 Attach the wires to the top and bottom posts on one side of the switch. It does not matter which wire is on top.
4 Press the switch into the rectangular hole until it locks into place.
© Travis Industries
Control Panel
(next to gas control valve)
4100322
19
100-01237_000