Network Control Software Application; Procedure To Utilize This Function - Eiki LC-XNB4000N Owner's Manual

Network Control Software Application

Procedure to utilize this function

It can help user to monitor and manage the projector(s) status in the local area network.

Register the projector(s) which needs to be controlled.
" Auto search " can help you to seek the projector(s) source easily.
After registering in the work group, you can start to control the projector.

G roup the projector(s) into different sections.
You can monitor the status easily by the sort of group name function in the network.

M onitor the status for each projector.
a.You can manage and change the monitoring content by System Parameter Setting.
b. The Lamp timer, filter working time or system warning feedback etc. can be known
by checking the status for projector(s).

C ontrol the booked projector(s).
The status can be refreshed and acquired by monitoring functions; you can also
operate the function easily by Network Control.
►
NOTE
To monitor and control the projector(including stand-by mode), the following
conditions need to be ready:
(1) Projector should already be powered on.
(2) Projector is connected to network.
(3) LED light of the projector network port shows normal. (Green light on, Orange
twinkle)
* Stand-by mode indictor: Green LED (Power) on the projector's control panel flashes.
Before Using Network Control Software
1. The projector should be powered on and the LAN wire is well connected to projector.
2. The LAN module ON/OFF item in SECURITY menu of OSD should be setting ON.
3. Make sure the computer and projector can connect to network. Network Control software needs to
arrange in TCP/IP network communication and the network cable.
►
NOTE:
IE8 browser & 1024x768 viewing resolution is recommended.
LAN
77