Network Control Software Application - Eiki LC-XIP2600 Owner's Manual

Network Control Software Application

Network Control Software Application
Procedure to utilize this function
R egister the projector(s) to be controlled only for the first time.

"Auto Search" finds and lists up the projectors in the network.
Assign Projector name and Group name for ease.
S ave the setting as a Project file.

By opening the Project file the setting can be recovered easily from next time.

M onitor the status of registered projectors up to 255 units.
Status of Power, Temperature and System and Input selection, used hours of Lamp
and Filter can be monitored.
For used hours the limit for alert can be set.

C ontrol registered projector one by one.
By using "Link" of Network Control Software each projector can be controlled.
NOTE
To monitor and control the projector(including stand-by mode), the following
conditions are needed to be ready:
(1) Projector is powered on or in stand-by mode.
(2) Projector is connected to network.
(3) LED light of the projector network port shows normal. (Green light on, Orange
twinkling)
37
LAN