Power On / Off - Eiki LC-XNB4000N Owner's Manual

Setting Up

Power ON / OFF

Zoom ring
POWER indicator
AC inlet
1.
2.
Power off?
Please press
key again to power off.
3.~4.
5.
Turning On The Power
Focus ring
1. Make sure that power cord is firmly and
2. The green Power indicator blinks slowly.
3. Remove the lens cover.
4. Press POWER button on the control panel or
Outlet
5. Rotate the zoom ring to adjust the screen size.
6. Rotate the focus ring to adjust the focus.

Turning Off The Power
1. Press the POWER button on the control
2. Press the POWER button again while the
3. When the projector enters "Standby" mode,
4. The projector cannot be turned on while red
5. If you don't use the projector for a long time,


14
correctly connected to the projector.
the remote control to turn on the projector.
WARNING
A strong light is emitted when the projector's
power is on. Do not look into the lens of the
projector or look inside of the projector through
any of the projector's openings.
panel or the remote control. The "power off"
confirmation message will appear.
message is shown on the screen.
the green Power indicator blinks slowly.
"Lamp indicator" is blinking slowly in cooling
mode.
remove power cord.
WARNING
Do not touch around the lamp cover and the
exhaust vents during use or just after use, since it
is too hot.
CAUTION
Do not turn off the AC power for 120 seconds
after the lamp is turned on. Doing so could cause
premature lamp failure.