Eiki LC-XNB4000N Owner's Manual page 93

Maintenance of Projector
WARNING
The projector uses a high-pressure mercury lamp.
The explosion of lamp with a loud bang or burn out could possibly cause injury or a fire.
When the bulb burst, it is possible for shards of glass to fly into the lamp housing; and
for gas containing mercury to escape from the projector's vent holes.
If the lamp has broken, do not check the inside of the projector. Please ventilate the room
immediately.
Do not touch or bring your face close to the broken pieces since it might get into your
eyes or mouth. In case of injury, seek medical advice immediately.
Disposal of a Lamp
Dispose of a lamp in accordance with the local recycling laws.
Do not put it to your trash.
Recycling Lamp's laws of the USA, go to www.lamprecycle.org.
Recycling Product's laws of USA, go to www.eiae.org.
Recycling Product's laws of Canada, go to www.epsc.ca.
For more information about recycling laws, please contact local government agency or
dealer.
CAUTION HOT
Before replacing the Lamp part, pay attention to the following items:
1.The Lamp is optional part. Contact the dealer for replacement lamp.
2. The lamp becomes very hot when in use. Turn the power off and disconnect the power
cord.
3.Wait 1 Hour before replacing the lamp.
4. Do not use old lamp part.
Additional
- In order to ensure the safe use of your projector, please contact your dealer to inspect
about once a year.
- Before maintenance, make sure the power cable is unplugged, allow the projector to
cool sufficiently. The high temperature state of the projector could cause a burn in and/
or malfunction to the projector.
-Never try to maintain the inside of the projector by yourself.
91