Figure 28. Connecting To The Dual Sc Fiber Optic Port - Allied Telesis AT-CM20x Series Reference Manual

Cabling a Dual ST Connector
To connect a fiber optic cable to a dual ST connector, perform the
following procedure:
Warning
Class 1 laser product.
Warning
Do not stare into the laser beam.
1. Connect the appropriate optical cable to the port, as shown in
Figure 28.

Figure 28. Connecting to the Dual SC Fiber Optic Port

2. Connect the other end of the optical cable to the link partner.
3. Power ON the end-nodes.
4. When the connection is established, the LK LED for the fiber optic port
should show green. If the LED is OFF, refer to "Troubleshooting" on
page 83 for instructions.
Converteon Media Converter Line Cards Reference Guide
1
2
A T - C
V 1 0 2
/1
LK A
T
T
X
S
M
R
X
790
73