Table 29. Stand-Alone - Converteon™ Module In Smart Missinglink Test Mode - Allied Telesis AT-CM20x Series Reference Manual

Stand Alone – Converteon™ Module Configured for Smart
MissingLink Test
Figure 49 on page 98 shows a stand-alone configuration for a
Converteon™ module (Module A) that has been configured for the Smart
MissingLink Test mode. Refer to "Smart MissingLink" on page 45 for
configuring the module of the Smart MissingLink Test mode. Module A is
connected to an AT-8524M (Switch 1) with a copper cable and to an
AT-8516F/SC (Switch 2) with a dual fiber cable.
Table 29 shows the Link (LK) LED status for each of the ports involved
when the cables are connected and disconnected from Module A's ports.
Table 29. Stand-Alone – Converteon™ Module in Smart MissingLink Test Mode
Network
Device
Switch 1
Port
Converteon™
LINK
Module A
Status
Switch 2
Converteon™ Module Cable Status
Port
All Cables
Link
Connected
Copper ON
LK LED
Copper ON
LK LED
Fiber ON
LK LED
Fiber ON
LK LED
Converteon Media Converter Line Cards Reference Guide
Copper Cable
Switch 1 to
Module A -
Disconnected
OFF
OFF
Blinking
Blinking
Module A
Transmit/
Receive
Fiber Cable
Disconnected
Blinking
Blinking
OFF
OFF
101