Table 32. Back-To-Back - Converteon™ Module In Smart Missinglink Test Mode - Allied Telesis AT-CM20x Series Reference Manual

Back-to-Back – Converteon™ Module Configured for Smart
MissingLink Test
Figure 50 on page 102 shows a back-to-back configuration for two
Converteon™ modules (Module A and Module B) that has been
configured for the Smart MissingLink Test mode. Refer to "Smart
MissingLink" on page 45 for configuring the module of the Link Test mode.
Module A is connected to an AT-8524M (Switch 1) with a copper cable and
to Module B with a dual fiber cable. Module B is connected to a
AT-8524M (Switch 2) with a copper cable.
Table 32 shows the Link LED status for each of the ports involved when
the cables are connected and disconnected from Module A's ports only.
Table 32. Back-to-Back – Converteon™ Module in Smart MissingLink Test Mode
Network
Device
Switch 1
Port
Converteon™
LINK
Module A
Status
Converteon™
Module B
Switch 2
Converteon™ Module Cable Status
Port
All Cables
Link
Connected
Copper ON
LK LED
Copper ON
LK LED
Fiber ON
LK LED
Fiber ON
LK LED
Copper ON
LK LED
Copper ON
LK LED
Converteon Media Converter Line Cards Reference Guide
Copper Cable
Switch 1 to
Module A -
Disconnected
OFF
OFF
Blinking
Blinking
Blinking
Blinking
Module A
Transmit/
Receive
Fiber Cable
Disconnected
Blinking
Blinking
OFF
OFF
Blinking
Blinking
105