Installing A Converteon™ Line Card Into A Converteon™ Chassis - Allied Telesis AT-CM20x Series Reference Manual

Chapter 2: Installation
Installing a Converteon™ Line Card into a Converteon™ Chassis
To install a Converteon™ line card into a Converteon™ chassis, perform
the following procedure:
Note
The Converteon™ line cards can be installed in any of the line card
slots located in the front panel of a Converteon™ chassis.
Note
For more information on the Converteon™ line cards, refer to
"Converteon™ Fast Ethernet and Gigabit Ethernet Line Cards" on
page 16.
Caution
Be sure to observe all standard electrostatic discharge (ESD)
precautions, such as wearing an antistatic wrist strap, to avoid
damaging the device. A line card can be damaged by static
electricity.
1. Remove the Converteon™ line card from its shipping package and
store the package in a safe place.
Note
You must use the original package if you need to return the unit to
Allied Telesis.
2. Select an empty line card slot in the chassis for the card.
3. Remove the AT-CV5PNL1 blank slot cover from the selected slot.
Keep the blank slot cover in a safe area in case you remove the line
card. The blank slot cover is used to keep dust from getting into the
chassis and to maintain proper airflow, cooling, and ventilation
throughout the chassis.
66