Figure 35: Connecting Cable To Fiber Optic Port - Allied Telesis DMC1000/100 Series Installation Manual

Figure 35. Connecting Cable to Fiber Optic Port
6. Verify that the media converter's transmitter port (TX) is connected to
the end node's receiver port (RX) and that the media converter's
receiver port (RX) is connected to the end node's transmitter port (TX).
For example, on the AT-DMC1000/ST media converter, connect the
red TX connector on the fiber-optic cable to the transmitter port on the
AT-DMC1000/ST media converter and connect the other connector to
the receiver port on the end node. Then connect the black RX
connector on the fiber-optic cable to the receiver port on the
AT-DMC1000/ST media converter and connect the other connector to
the transmitter port on the end node.
7. Secure the fiber optic cable to the media converter using the other
cable tie as described below and shown in Figure 36:
a. Insert the cable tie through the other integral notch on the mounting
bracket.
b. Route the cables next to the cable tie.
DMC1000/100 Series Media Converters Installation Guide
51