Cabling A Rs-232 Console Port (At-Cm70S Line Card Only); Figure 35. Connecting A Management Cable To The Console Port On An At-Cm70S Line Card - Allied Telesis AT-CM20x Series Reference Manual

Chapter 2: Installation
Cabling a RS-232
Console Port
(AT-CM70S Line
Card Only)
When connecting to the RS-232 console port on the front of the
AT-CM70S line card, observe the following guidelines:
Once the connection is done, set the terminal or terminal emulation
program to the following defaults:
Baud rate: 115200 bps
Data bits: 8
Parity: None
Stop bits: 1
Flow control: None
Note
The settings are for a DEC VT100 or ANSI terminal, or an equivalent
terminal emulation program.
To connect to the RS-232 console port on the AT-CM70S line card,
perform the following procedure:
1. Connect the 8-pin Mini-DIN end of the RS-232 serial cable to the
console port on the front of the AT-CM70S line card, as shown in
Figure 31.
Figure 35. Connecting a Management Cable to the Console Port on an
2. Connect the other end of the cable to an RS-232 port on a terminal or
a personal computer with a terminal emulation program.
3. Power ON the end-nodes.
When the connection is established and the console port is operational,
the CONSOLE LED for the console port should show green.
F
P
1
C PU R
ES ET
C
O 2
N
R C L
S
N M L
O
L
E
L O T C
N M L
3
L/ A FD
10 0
4
T
X
R DY
A IS 1
2
910
AT-CM70S Line Card
78