Table 28. Stand-Alone - Converteon™ Module In Missinglink™ Test Mode - Allied Telesis AT-CM20x Series Reference Manual

Appendix A: Technical Specifications
Table 28. Stand-Alone – Converteon™ Module in MissingLink™ Test Mode
Switch 1
Port
Converteon™
LINK
Module A
Status
Switch 2
Stand-Alone – Converteon™ Module Configured for MissingLink™
Test
Figure 49 on page 98 shows a stand-alone configuration for a
Converteon™ module (Module A) that has been configured for the
MissingLink™ Test mode. Refer to "MissingLink™" on page 44 for
configuring the module of the Missing Link™ Test mode. Module A is
connected to an AT-8524M (Switch 1) with a copper cable and to an
AT-8516F/SC (Switch 2) with a dual fiber cable.
Table 28 shows the Link (LK) LED status for each of the ports involved
when the cables are connected and disconnected from Module A's ports.
Network Port
Device Link
Copper
LK LED
Copper
LK LED
Fiber
LK LED
Fiber
LK LED
Converteon™ Module Cable Status
Copper Cable
All Cables Switch 1 to
Connected Module A -
Disconnected
ON OFF
ON OFF
ON OFF
ON OFF
Module A
Transmit/
Receive
Fiber Cable
Disconnected
OFF
OFF
OFF
OFF
100