Table 30. Back-To-Back - Converteon™ Module In Link Test Mode - Allied Telesis AT-CM20x Series Reference Manual

Back-to-Back – Converteon™ Module Configured for Link Test
Figure 50 on page 102 shows a back-to-back configuration for two
Converteon™ modules (Module A and Module B) that has been
configured for the Link Test mode. Refer to "Link Test" on page 44 for
configuring the module of the Link Test mode. Module A is connected to
an AT-8524M (Switch 1) with a copper cable and to Module B with a dual
fiber cable. Module B is connected to a AT-8524M (Switch 2) with a copper
cable.
Table 30 shows the Link LED status for each of the ports involved when
the cables are connected and disconnected from Module A's ports.
Table 30. Back-to-Back – Converteon™ Module in Link Test Mode
Network
Device
Switch 1
Converteon™
Module A
Port
LINK
Status
Converteon™
Module B
Switch 2
Converteon™ Module Cable Status
Port
All Cables
Link
Connected
Copper ON
LK LED
Copper ON
LK LED
Fiber ON
LK LED
Fiber ON
LK LED
Copper ON
LK LED
Copper ON
LK LED
Converteon Media Converter Line Cards Reference Guide
Copper Cable
Switch 1 to
Module A -
Disconnected
OFF
OFF
ON
ON
ON
ON
Module A
Transmit/
Receive
Fiber Cable
Disconnected
ON
ON
OFF
OFF
ON
ON
103