Calibration - GRAPHTEC CS610 User Manual

5.6 Calibration

Calibrate the scanner if scanning quality is observed to deteriorate, with scanned results
such as those described below:
The scanned image is distorted
Areas of uneven color appear in the scanned image
Other unsatisfactory results (but not including problems related to media quality, such
as folds, wrinkling, or paper curling)
• Handle the calibration sheet with care so that it does not get bent. To prevent
soiling, store it in its special storage box. The calibration sheet cannot be used if it
is bent or soiled.
• The calibration sheet is a paper product. Do not attempt to clean it with any type
of liquid cleaner.
• The calibration sheet is a consumable item. Replacement sheets can be
purchased from your sales representative or nearest Graphtec vendor.
Preparation and checks
Recommended usage environment
Monitor: 1024 × 768 pixels, High Color or better resolution
A low-resolution monitor will make it difficult to discern any problem areas.
The calibration method for the CS610 scanner differs according to whether the calibration
is for a thin document or a thick document.
If a thin document will be scanned, use the thin calibration sheet and select the thin
document setting at the scanner.
If a thick document will be scanned, use the thick calibration sheet and select the thick
document setting at the scanner.
Please see Section 4.2, "Loading a Document" for further details.
Launching the Scanner Adjustment Program
(1) Connect the scanner to the PC and switch on the scanner. Switch on the PC.
(2) Install Scanning Master 21+ (OPS112) if it is not already installed.
(3) Click the Start button, then select
Adjustment.
(4) Click Scanner Adjustment to launch the Scanner Adjustment program.
CS610/CS510/IS210
Programs > Scanning Master 21+ > Scanner
5. DAILY MAINTENANCE
5 – 7