GRAPHTEC CS610 User Manual page 61

4. LOADING A DOCUMENT
4.2 Loading a Document
Document Loading Flowchart (CS610 only)
Attach the document
support wires.
(See"Section 2.3, Attaching the
Document Supports" on page 2-12)
With the scanner in ITA mode
and without a document
loaded, press the REVERSE
key to lower the top cover (the
ITA LED flashes while the cover is
being lowered).
When the ITA LED has stopped
flashing, remove your finger
from the REVERSE key.
Set the document thickness in
ITA mode.
(See "Detecting the thickness of the
document to be scanned" [When
scanning a thin document (less
than 1.5 mm thick)] on page 4-8.)
Set the document guides.
(See "How to use the document
guides" in the following section. )
4 – 4
Start document loading
No
Is the document
thicker than 1.5 mm
Remove the document guides.
Start scanning.
Yes
Attach the document
support unit.
(See "Section 2.3, Attaching the
Document Supports" on page 2-12)
Set the document guides.
(See "How to use the document
guides" in the following section.)
Set the document thickness
in ITA mode.
(See Detecting the thickness
of the document to be
scanned [When scanning a
thick document (thicker than
1.5 mm)] on page 4-7.)
CS610/CS510/IS210