GRAPHTEC CS610 User Manual page 41

3. PREPARING TO OPERATE THE SCANNER
Select the connected server, and then click [OK].
(4) Click [Register] to connect from the Utility.
(5) Click [Connect].
(6) After connecting with the utility, specify the CS610-11eN/11eN-PRO, CS510-11eN/
11eN-PRO, CS510-06eN-PRO, or IS210-11eN/11eN-PRO driver as appropriate, and
perform installation. For further details on the installation procedure, see Section 3.5,
"Installing the Driver Software".
When using the CS610-11eN/11eN-PRO, CS510-11eN/11eN-PRO, CS510-06eN-
PRO, or IS210-11eN/11eN-PRO connected to an Ethernet interface, be sure to
launch the Graphtec Network Utility and click the [Connect] button. Furthermore,
when you have finished using the scanner, click the [Disconnect] button to put the
scanner in a status that enables it to be used with other computers.
If the [Connect] button is displayed in gray, the scanner is being used with another
computer. Please connect the scanner when the [Connect] button display returns to
black.
When the scanner is connected to the computer and no commands are
received, it will be disconnected after approximately 10 minutes.
If the scanner is disconnected with the Scan window left open, the scanner will
remain in the scanning status, and cannot be used other computers. In this case,
the scanner must be turned off and then on again
The scanner's network interface sleeps when the scanner is in energy-saving
mode. When connecting the scanner, bring it out of the energy-saving mode.
3 – 14 CS610/CS510/IS210