KVH Industries TracPhone FB250 User Manual page 104

2. For each Phone/Fax port, set the call type for incoming and outgoing calls.
Note
Port 1 is the connector closest to the antenna connector, and Port
2 is the connector closest to the ISDN connector.
The call types are described in more detail in Selecting the call type on
page 39.
• For Incoming calls, you can check Standard or 3.1 kHz Audio or both.
If you check both, any device connected to the Phone/Fax interface will
react (ring) on incoming calls.
If you select e.g. Standard, the Phone/Fax interface will only react on
calls made to the Standard phone number.
• For Outgoing calls, you can select either Standard or 3.1 kHz Audio.
The selected type will be used by default, if possible, for any outgoing
call. Note, however, that fax machines and modems must use 3.1 kHz
Audio.
Note
You can override the default setting for outgoing calls by dialing
1* (force the call to Standard) or 2* (force the call to 3.1 kHz
Audio) before the number. For further information, see
Overriding the default outgoing call type on page 40.
3. Click Apply.
Chapter 4: Using the web interface
Setting up the interfaces 91