Table of Contents
Advertisement
You may follow the quick installation steps if the following
conditions are true:
There will only be one RangeLAN2 7500 on this
network
You will use all the software default values (MASTER,
domain 0, IP address 192.0.1.2)
You will not be setting security IDs on your network
All RangeLAN2 computers are configured as STATIONs
or ALTERNATE MASTERs
If your installation meets the preceding criteria, proceed with the
following instructions:
Note
FCC regulations mandate that the RangeLAN2 7500
antenna not be alterable. Therefore, RangeLAN2
7500 uses a custom antenna connector. Do not
attempt to use a different antenna or you may damage
the connector and the RangeLAN2 7500 unit.
2. Quick Installation
1. Insert the floppy diskette labeled "Access
Point" into the drive on the front of the
RangeLAN2 7500. You can ignore this
step if you are using a RangeLAN2 7501.
2. Firmly screw the end of the RangeLAN2
antenna cable onto the antenna connector at
the back of the RangeLAN2 7500
clockwise.
5
Advertisement
Table of Contents
