Snmp Supported Traps - Proxim RangeLAN2 7500 User Manual

The Read-Only Community parameter specifies a
community supported by the RangeLAN2 7500. Ac-
tions permitted by this community are "read-only." Only
GET and GET-NEXT operations are supported within
the scope of this community. SET attempts using this
community will result in rejection of the attempt with a
general error response and the generation of an authenti-
cation trap (if so enabled).
The Read-Write Community parameter specifies the a
community supported by the RangeLAN2 7500. Ac-
tions permitted by this community are "read-write."
GET, GET-NEXT, and SET operations are supported
within the scope of this community.
The Trap Target Community parameter specifies the
community that will be used by the RangeLAN2 7500
when generating TRAP PDUs to remote managers.
The Trap Target IP Address specifies the IP address of
the device to which generated TRAP PDUs will be sent.
A value of 0.0.0.0 disables trap generation.
Authentication Traps may be enabled or disabled.

SNMP Supported Traps

Cold Start - Sent when the RangeLAN2 7500 reboots
Link up - Sent by each interface at start-up
Link Down - Sent when the RangeLAN2 7500 software
cannot initialize or communicate with the radio
32