Stop, Delete Or Hold An Active Job - Oce TCS500 User Manual

Stop, delete or hold an active job

Stop, delete or hold an active job
Introduction
This section describes how to 'Stop', 'Delete' or 'Hold' an active job on the printer
operator panel. You can also 'Stop', 'Delete' or 'Hold' print jobs in the Océ Queue
Manager.
How to 'Stop', 'Delete' or 'Hold' an active print job on the printer operator panel
Press the 'Stop' key on the printer operator panel.
1.
The printer stops immediately.
A dialog box on the screen asks the user to 'Resume' or 'Stop' the job.
When you do not select an option, the printer automatically continues the printing
after 5 minutes.
[120]
Use the lower softkeys to indicate if you want to 'Resume' or 'Stop' the job.
2.
If you select 'Stop' a new dialog box appears where you can 'Delete' or 'Hold' the job.
Use the lower softkeys to indicate if you want to 'Delete' or 'Hold' the job.
3.
If you select 'Delete' the active job is permanently deleted from the print queue.
If you select 'Hold' the active job is put on hold in the print queue. The Océ TCS500
allows you to change the properties of the job on hold.
attributes of jobs on hold in the Océ Queue Manager' on page
Note: When you delete a job, the drying is not skipped. Press the key for 'Skip
drying' to cancel the drying during the drying time. You can use the 'Feed & cut'
wizard to cut the output.
148 Chapter 6 Use the Océ TCS500 for print jobs
(see 'User operations in the Océ Queue Manager' on page 99)
(see 'How to change
100)