Oce ColorWave 300 User Manual page 281

Caution:
Always store printheads near the printer or allow the printheads to adjust to the printers
environmental conditions before you insert them in to printer.
How to remove a printhead
From the'HOME' screen select the 'System' tab.
1.
Select the 'Setup' tab.
2.
Use the scroll wheel to go to the 'Printheads'('Replace printheads') wizard.
3.
Open this section with the confirmation button.
4.
An introduction screen displays the message 'Use this wizard to replace printheads. A roll
5.
is needed for calibration.'
Press the key for 'Next >'.
6.
The screen displays the message 'Select roll to use'.
The system does a calibration at the end of the wizard. You can only calibrate on the de-
fined media types
possible with the media available on the printer, the system asks you to load the correct
media. When calibration is possible with one of the rolls, the system automatically uses
the correct media roll. When calibration is possible with both rolls, use the scroll wheel
to select the media roll and press the confirmation button to select the roll.
Press the key for 'Next >'.
7.
'Use the 'Print quality' wizard' on page
Chapter 7 - Maintain the Océ ColorWave 300 multifunction printer
Replace a defective printhead
267. When calibration is not
281