Oce ColorWave 300 User Manual page 119

Settings group
'Regional settings'
'Current date and time'
'Print queue management'
'Smart Inbox management'
'Logging and accounting'
'Printer properties'
'Scanner properties'
'Stamps 1 to 4'
'Stamps 5 to 8'
'Stamps 9 to 12'
Click 'Edit' in the settings group bar or click the value of a single setting.
2.
(see 'How to edit a setting' on page
Click 'Ok' to confirm your entries or 'Cancel' to reject your entries.
3.
Description
The regional settings are configured during the
installation of your system. Here you can change
the initial configuration.
Set the actual date, time and time-zone.
Define how jobs are managed in the print queue.
Define how jobs are managed in the Smart Inbox-
es.
Define logging and accounting data.
Define the general printer behavior.
Define the general scanner behavior. Only available
if a scanner is installed.
Configure and enable stamps for copy jobs.
Configure and enable stamps for copy jobs.
Configure and enable stamps for copy jobs.
88)
Chapter 4 - Define your workflow with the Océ Express WebTools
Define the system preferences
Note:
You can toggle between the 'First lan-
guage' and the 'Second language' on the
user panel.
Note:
Every time you change the 'Measurement
unit', the controller recalculates the values
from millimeter to inches and vice versa.
If you reverse to the original value of this
setting a slight calculation difference can
occur due to rounding differences.
119