Oce ColorWave 300 User Manual page 269

Use the 'Print quality' wizard
possible with one of the rolls, the system automatically uses the correct roll of media.
When calibration is possible with both rolls, continue with step 5.
Use the scroll wheel to select the required roll and press the confirmation button to select
a media roll for the calibration.
Press the 'Next >' softkey.
6.
The screen displays the message 'Preparing media...' The system prepares for the quality
check.
The screen displays feedback about the calibration process. The system does a nozzle
failure recovery and alignment.
You can stop the calibration process at any time. Press the key for 'Cancel' to stop the
calibration process.
In case more than 75 nozzles fail, a 'Printheads failing' message appears. Then you must
replace the printhead, using the 'Printheads'('Replace printhead') wizard .
Chapter 6 - Ensure the best output quality 269