Engine Oil Inspection; Brake Inspection - KYMCO Aglity 50 Owner's Manual

OPERATION
PRI - Engine oil level inspection
NOTE: Park your scooter on the main stand, on level ground.
1 1 1 1 1
1. Unscrew the dip stick 1, remove it and wipe it with a clean
cloth
2. Reinsert the dip stick until the threaded part of the dip stick
touches the engine case. Do not thread the dipstick into the
engine case.
3. Remove the dip stick again and inspect the oil level on the
stick. The engine oil level should be above the "L" mark but
not higher than the "F" mark. Add or remove oil as required.
Do not overfill the engine with oil. Overfilling the en-
gine can cause oil leaks and/or oil contamination of
the air filter element. Always make sure the oil level is
above the "L" mark but not higher than the "F" mark.
Use extreme caution when performing the oil level in-
spection or any other checks if the scooter's engine
has been recently run. The engine oil, engine case and
F
muffler can become very hot creating a burn hazard.
L
PRI - Rear brake lever inspection (left lever)
Your scooter requires the proper brake lever free-play so the
brakes will be responsive and will not drag, causing prema-
ture wear to the brake pads. The free-play is the measured
distance between the brake lever at rest and the point at which
the brake first begins to engage.
1. Measure the free-play at the left brake lever end:
2. Use the cable adjuster on left brake lever perch for minor
0.4 - 0.6 in
(10 - 20 mm)
0.4 - 0.6 in (10 - 20 mm).
free play adjustment.
19