Fuse - KYMCO Aglity 50 Owner's Manual

MAINTENANCE
Battery removal & installation
The battery 5 is in the battery box below seat.
NOTE: Always keep ignition switch OFF when servicing
the battery.
1. When removing the battery for charging or replacement, dis-
connect the negative (-) terminal lead from the battery first,
then disconnect the positive (+) terminal lead.
2. When installing the battery, connect the positive terminal
lead (+) first, then the negative terminal lead (-).
Fuses
When frequent fuse failures occur, it usually indicates a short
circuit or an overload in the electrical system.
NOTE: See your KYMCO dealer for electrical system
diagnosis and repair.
5 5 5 5 5
Fuse replacement
FUSE SIZE: 7A
(One MAIN fuse & one SPARE)
1. Open the fuse holder 6.
Pull the fuse holder clips
7 out of the holder.
2. Slide the fuse 8 out of
the holder clips.
3. Install a new fuse 8 of
the proper specification
into the holder clips.
4. Press the fuse and the
holder clips 7 back into
the holder.
5. Close the fuse holder 6
and set it back in place.
Never use a fuse with a different rating from that speci-
fied. Serious damage to the electrical system or a fire
hazard may result, causing a dangerous loss of lights
or engine power.
6 6 6 6 6
7 7 7 7 7
8 8 8 8 8
6 6 6 6 6
7 7 7 7 7
8 8 8 8 8
39