Transmission Fluid Change - KYMCO Aglity 50 Owner's Manual

MAINTENANCE

Transmission fluid change

1. Place the scooter on its main stand.
2. Place a suitable container (drain pan) under the transmis-
sion case on its left side. Remove the drain bolt 1 to
drain the fluid.
42
2 2 2 2 2
1 1 1 1 1
3 3 3 3 3
3. After the fluid has drained out, reinstall the drain bolt with a
new sealing washer and tighten it to the specified torque.
Transmission fluid drain bolt torque: 15 lb-ft (20 N-m)
4. Remove the transmission fluid filler bolt 2.
5. Add the exact specified fluid through the fluid filler hole 3.
Transmission fluid type:
Transmission fluid capacity (Agility 50): 0.12 qt (0.11 L)
Transmission fluid capacity (Agility 125): 0.21 qt (0.20 L)
NOTE: The fill amount specified is the amount to use after
completely draining the used transmission fluid.
Do not exceed the specified amount when adding trans-
mission fluid. If too much fluid is added to the trans-
mission case it could be forced into the air cleaner as-
sembly during operation, causing air filter contamina-
tion and poor engine performance.
Using the wrong transmission fluid type or viscosity
may cause premature transmission component wear.
SAE 90