Replacing The Dc Output Fuse - Xantrex TC1012 Owner's Manual

Replacing the DC Output Fuse

To replace the DC Output Fuse:
1. Disconnect all AC and DC sources to the charger.
2. Locate the fuse cover on the charger's top panel (see
3. Loosen the screw on the fuse cover using a Phillips
4. Pull out the blown fuse(s) gently, using the provided fuse
5. Install a brand new fuse(s) with same type and rating as
6. Replace the fuse cover making sure that it aligns and fits
7. Tighten the screw on the fuse cover but do not over-
8. Reconnect all AC and DC sources to the charger.
975-0401-01-01
Figure 1-1, "Truecharge™ 2 Battery Charger" on page
1–4).
screwdriver.
NOTE: The screw will not separate from the cover.
puller.
NOTE: The fuse puller is located on the inside of the
cover.
the old one.
NOTE: Choose Littlefuse type 257 or equivalent.
perfectly leaving no space for moisture or small debris to
enter the compartment.
tighten.
Replacing the DC Output Fuse
3–11