Charging Batteries - Xantrex TC1012 Owner's Manual

Operation

Charging Batteries

Before you start to charge batteries read the "Important
Safety Instructions" on page v and follow all safety
precautions when working with batteries.
To charge your batteries:
1. If possible, disconnect all loads from the battery, by opening
disconnect switches or by switching the loads off.
2. Ventilate the area around the battery thoroughly.
Review the charging instructions supplied by the manufacturer of
your batteries and follow all safety precautions and the required steps.
3. Apply AC power to the Truecharge™ 2 Battery Charger by: closing
the AC breaker or turning the generator on.
All onboard display indicator LEDs will illuminate for one second
(power on test) as the initialization sequence runs. After initialization,
the indicator LEDs will display present status and settings.
During charging, the Charging Output (%) LEDs will show the total
current being delivered to the battery bank as well as any DC load
applied. The charger fan may activate as well.
4. After charging is completed, re-connect all loads to the battery.
See table next.
2–8 975-0401-01-01