Standard And Protection Features - Xantrex TC1012 Owner's Manual

Introduction

Standard and Protection Features

The Truecharge™ 2 Battery Charger provides the following standard
features:
•
•
•
•
•
•
•
•
•
1.Model TC1012 has one output and model TC1512 has two outputs. All other models
have three outputs. Each output (for models with 2 or 3 outputs) can charge different bat-
teries that either have the same chemistry or can tolerate the same charge sequence.
2.The charger can be programmed with custom charge setpoints using PC interface. This
programming can only be done using a special configuration tool operated by Xantrex or a
designated OEM.
3.The charger can initiate charging a non-damaged but zero voltage battery.
4.Part number: 808-8040-00
5.Part number: 808-0232-01
1–2
1
three full current rated outputs
battery monitoring functions while in float mode or rest
mode
correct charging voltage for your batteries when
connected to almost any single phase AC power outlet in
the world
low electromagnetic interference (EMI)
automatic charge resumption after AC power interruption
programmable custom charge sequence
fully discharged battery charging
an optional remote panel
15 m (50 ft) away for remote control and monitoring.
an optional battery temperature sensor
battery temperature voltage compensation from -25 to
70 °C (-13 to 158 °F)
3
4
which can be mounted up to
5
2
(BTS) provides
975-0401-01-01