Life Monitor - Muratec MFX-1300 Field Engineering Manual

3.10.1 Life Monitor

The life monitor displays the current software version, the total number of pages scanned, printed, and
transmitted, the number of drums replaced and the total page count on the current drum.
Note: The All RAM Clear setting does not clear the life monitor. To clear, see below.
1. Press Program key, *, 9, ENTER.
Life Monitor
2. Press One-touch A-P to select the desired display. Press STOP to exit the test mode.
The following options are available:
One-touch A = displays software version
One-touch B = displays machine's serial number
One-touch C = displays date of installation
One-touch D = displays total pages scanned
One-touch E = displays total pages printed
One-touch F = displays total pages transmitted
One-touch G = displays drum replaced
One-touch H = displays total pages printed on current drum
One-touch I = displays toner replaced count
One-touch J = displays toner life
One-touch K = displays fuser replaced count
One-touch L = displays fuser life
One-touch M = displays transfer roller replaced count
One-touch N = displays transfer roller life
One-touch O = displays drum operation time (sec)
One-touch P = displays printer operation time (sec)
If One-touch A is selected, you'll see the following message on the LCD.
Board Number?
Use the numeric keypad to select the optional board number as shown in the following table.
ROM
Flash ROM on Main control PCB
Version of Optional module's
ROM
Version of Modem
Built-in CPU ROM
The software version of each board will be shown on the LCD.
Board Number?
0:D88L USA A0A0A0
The most left character on the lower line shows the board number selected.
Press STOP to exit the test mode
Numeric keypad
0
1 - 8
#
* (asterisk)
3-65