Muratec MFX-1300 Field Engineering Manual page 29

Fusing temperature
1) Warming Up After the initialization of the printer, warming up of the printer starts and the Heater
Lamp turns ON until the temperature of the Heater Roller reaches approx. 180 °C.
2) Printing When the printer obtains the printing command from its controller, the Heater Roller
is maintained at 180 °C.
After printing, the printer turns to standby mode. The fuser kept at low temperature.
3) Standby mode The Heater Roller maintained at approx. 160 °C.
4) Sleep mode In this mode, saving the power.
MFX-1300/MFX-1200:
Temperature
( F) ( C)
392 200
356 180
320 160
Warming up
Power ON
MFX-1700/MFX-1600:
Temperature
( F) ( C)
401 205
374 190
338 170
Warming up
Power ON
Post card printing only
Printing
Standby mode
Post card printing only
Printing
Standby mode
2-17
Time
Sleep mode
Time
Sleep mode