Home Sensor / End Sensor; Fbs Motor - Muratec MFX-1300 Field Engineering Manual

HOME SENSOR / END SENSOR

1. Remove the TOP FRONT COVER, THE TOP RIGHT COVER and the TOP LEFT COVER.
2. Remove the PANE and the CONTACT GLASS.
3. Remove the HARNESS COVER C mounting screw, and then remove the HARNESS COVER C.
4. Remove the END SENSOR. Remove the HOME SENSOR.
END sensor

FBS MOTOR

1. Remove the TOP FRONT COVER, the TOP RIGHT COVER and the TOP LEFT COVER.
2. Remove the BOTTOM CORNER COVER.
3. Remove the HINGE SCREW and the HARNESS HOLDER mounting screw, and then remove the
PLATEN COVER Assembly.
4. Remove the TOP REAR COVER.
5. Remove the GROUND PLATE mounting screw, and then remove the GROUND PLATE.
Remove nine LEFT ANGLE mounting screws, and then remove the LEFT ANGLE.
6. Remove four HINGE STUD mounting screws, and then remove the HINGE STUD.
Harness cover C
Left angle
Ground plate
5-33
HOME sensor
Hinge STUD