Muratec MFX-1300 Field Engineering Manual page 49

Memory Switch A:0 - Dialer
Initial
Switch
Setting
7 0 Factory use only
6 0 Factory use only
5 0 Factory use only
4 0 Factory use only
3 0 DIS detect time after dialing
0: 80 sec
1: 70 sec
2 1 Factory use only
1 1 Dial tone detection
0: Do not dial
1: Dial
0 0 Phone line type
0: PSTN
1: PBX
Memory Switch A:1 - Dialer
Initial
Switch
Setting
7 0 Factory use only
6 0 Factory use only
5 0 Factory use only
4 0 Factory use only
3 0 PBX mode dial pause
2 0
1 1
0 1
Memory Switch A:2 A:4 --- Factory use only
Adjust
Sets the time DIS signal is detected after dialing a
number.
Determines if the unit proceeds with dialing or
indicates an error if no dial tone is detected within
five seconds of going off-hook.
When set to PSTN, the unit checks for dial tone and
acts according to the setting of memory switch A:0,
bit 1. When set to PBX, the unit always dials a given
number of seconds after going off-hook. Memory
switch A:1 sets the number of seconds.
Adjust
Sets the number of seconds the unit waits before
dialing when memory switch A:0 bit 0 is set to PBX
mode.
Switch 3 2 1 0
3-19
Usage/Comments
Usage/Comments
Pause time
0 0 0 0 0 sec
0 0 0 1 1 sec
0 0 1 0 2 sec
0 0 1 1 3 sec Initial setting
0 1 0 0 4 sec
0 1 0 1 5 sec
0 1 1 0 6 sec
0 1 1 1 7 sec
1 0 0 0 8 sec
1 0 0 1 9 sec
1 0 1 0 10 sec
1 0 1 1 11 sec
1 1 0 0 12 sec
1 1 0 1 13 sec
1 1 1 0 14 sec
1 1 1 1 15 sec