Switch Housing And End Cap Installation - Casablanca Academy Owner's Manual

SWITCH HOUSING AND END CAP INSTALLATION -

Step 9d. Plug the male Molex plug into the female
Molex plug, aligning color and letters.
NOTE: The Molex plug will only connect if the
letters and colors are matched on both plugs. Do
not force the plug together.
Step 9e. Tuck all wires into the switch housing.
Figure #4.
Step 9f. Find the keyed slots on the switch housing,
and the notches on the adapter plate. Line these up
and assemble the adapter plate to the switch housing
with the 4 adapter plate screws. Figure #5.
Step 9g. Place the cover plate cap onto the adapter
plate and secure using the Cover Plate screw. Figure
#2
Step 9h. Line up the notches on the cap plug to
the slots in the cover plate cap and snap into place.
Figure #6.
18 18 18
CONT
MOLEX
PLUG
Figure #4
Figure #5
Figure #6
A
cAdemy
LIGHT FIXTURE INSTALLATION
ACADEMY GALLERY ONLY
Step 10. If you have purchased a Academy Gallery ™ your fan comes with a light kit. Please follow the following
steps to install your light kit.
Lower Glass Light Kit
Switch Housing Installation
Step 10a. Partially install two of the three switch
housing screws onto the switch housing adapter plate
as shown in Figure #1.
Step 10b. Thread the Molex Plug through the hole in
the center of the switch housing as shown in Figure
#2. Align the two keyholes with the two screws that
were installed on the switch housing adapter plate.
Place the switch housing over the two screws and
rotate it clockwise so that the two screws are holding
the switch housing as shown in Figures #2 and #3.
Step 10c. Align the screw hole on the switch housing
with the screw hole in the switch housing plate and
insert the third screw as shown in Figure #3. Then
tighten all three screws with the provided screwdriver.
G
ALLery
Switch Housing
Screw (3)
Glass Cover Lower Bulb (3)
Finial
Figure #1
Switch Housing Screws
Molex Plug
Figure #2
SWITCH
HOUSING
Figure #3
SCREWS
19