Blade Installation; Light Kit Installation - Casablanca Antion C39G199L Owner's Manual

BLADE HARDWARE
Blades (5)
Blade Irons (5)

BLADE INSTALLATION

Step_1._ Attach a blade to a blade iron by first
pressing the blade iron onto the blade, then
attaching the blade iron using 4 blade screws and
blade washers as shown in Figure #2. Using the
provided screwdriver, tighten securely by hand
only. Repeat for each blade assembly.
Step_2._ Attach a blade/blade iron assembly to the
flywheel by using two blade iron screws provided.
Place the end of the blade iron on the flywheel as
shown in Figure 3. Insert the screws one by one
using the provided screwdriver. Tighten securely by
hand only. Repeat for each blade/blade iron assembly
until all five blades are attached to the fan.
CAUTION:
Blade screws must be tightened securely
before operating the fan.
14
Blade
Blade
Blade Iron
Screw Driver
Washers (5)
Screws (5)
Screws (5)
Blade Screws
Blade Washers
Blade Iron
Blade
FIGURE_1.
Fly Wheel
Blade Iron
Blade Iron
FIGURE_2.
Screws
LIGHT KIT HARDWARE
Glass Fitter
Glass Bowl
E11 50W Halogen Bulb (2) Glass Cover

LIGHT KIT INSTALLATION

Step_1._ To attach the Glass Fitter partially install
two Glass Fitter Screws into the switch housing
mounting plate. Figure 1.
Step_2._ Align the keyhole slots in the Glass Fitter
with the Fitter Screws. Figure 2.
Note: Ensure the foil side of the fitter is facing
down otherwise the light kit will not install
properly.
Step_3._ Turn the Glass Fitter counterclockwise until
the Fitter Screws are firmly situated in the narrow
end of the keyhole slots.
Step_4._ Install the remaining screw into the Glass
Fitter. Figure 3.
Step_5._ Tighten all three screws firmly.
a
™
ntion
Glass Fitter
Screw (3)
Light Kit
Light Kit Screw
Glass Finial
(4)
Switch Housing
Mounting Plate
Fitter Screws
FIGURE_1.
FIGURE_2.
Fitter Screw
FIGURE_3.
15