Connecting The Xga / Audio Line Transmitter / Receiver - Kramer TP-104 User Manual

Connecting the XGA / Audio Line Transmitter / Receiver

8 Connecting the XGA / Audio Line Transmitter / Receiver
You can use the TP-121 and TP-122 to configure an XGA/Audio Line-to-Twisted
Pair Transmitter and Receiver system.
To connect the TP-121 XGA / Audio Line Transmitter with the TP-122 XGA /
Audio Line Receiver, as the example in Figure 8 illustrates, do the following:
1. On the TP-121, connect the XGA source (for example, a laptop's graphics
card) to the XGA INPUT HD15F connector and an audio source to the
AUDIO IN 3.5mm mini jack, for example, using a Kramer C-GMA/GMA
cable (VGA HD15M +Audio jack to VGA HD15M +Audio jack)
Alternatively, you can connect an XGA source to the XGA INPUT
HD15F connector, and a separate audio source to the AUDIO IN 3.5mm
mini jack.
2. On the TP-122, connect the XGA OUT HD15F connector to the XGA
acceptor (for example, a display), and connect the AUDIO OUT S/PDIF
RCA connector to the digital audio acceptor (for example, an AV
Receiver), and the ANALOG 3.5mm mini jack to the analog audio
acceptor (for example, a stereo audio recorder).
3. Connect the LINE OUTPUT RJ-45 connector on the TP-121 to the LINE
IN RJ-45 connector on the TP-122, via UTP cabling (with a range of
more than 300ft (>100m)), see section 8.1.
4. Connect the 12V DC power adapter to the power socket and connect the
adapter to the mains electricity on both
The signal from the XGA source is transmitted via CAT5 cable, decoded
and converted at the XGA OUT HD15F connector to the XGA acceptor.
5. On the TP-122:
3
Adjust the video output signal level and/or cable compensation
equalization level, if required
If necessary, set the H SYNC and V SYNC switches
1 Not supplied. The complete list of Kramer cables is on our Web site at http://www.kramerelectronics.com
2 If you cannot connect the power to both the TP-121 and TP-122, you can just connect the power to the TP-122
3 Use a screwdriver to carefully rotate the trimmer, adjusting the appropriate level
4 By default, both switches are set down (for negative V SYNC and H SYNC polarity)
2
the TP-121 and the TP-122.
4
, on the underside
1
.
11