Connecting The Tp-121Edid Xga / Audio Line Transmitter - Kramer TP-121EDID User Manual

4.1 Connecting the TP-121EDID XGA / Audio Line Transmitter

You can use the TP-121EDID together with the TP-122 XGA / Audio Line
1
to configure an XGA/Audio Line-to-Twisted Pair Transmitter and
Receiver
Receiver system.
Before connecting the transmitter and receiver system you can acquire the
EDID from the display or set the system to the default EDID, see section
To connect the TP-121EDID XGA / Audio Line Transmitter with the TP-122
XGA / Audio Line Receiver, as the example in
following:
1. On the TP-121EDID, connect the XGA source (for example, a laptop's
graphics card) to the XGA INPUT 15-pin HD (F) connector and an audio
source to the AUDIO IN 3.5mm mini jack, for example, using a Kramer
C-GMA/GMA cable (VGA 15-pin HD (M) +Audio jack to VGA 15-pin HD
(M) +Audio jack)
XGA INPUT 15-pin HD (F) connector, and a separate audio source to the
AUDIO IN 3.5mm mini jack.
2. On the TP-122, connect the XGA OUT 15-pin HD (F) connector to the
XGA acceptor (for example, a display), and connect the AUDIO OUT
S/PDIF RCA connector to the digital audio acceptor (for example, an AV
Receiver), and the ANALOG 3.5mm mini jack to the analog audio acceptor
(for example, a stereo audio recorder).
3. Connect the LINE OUTPUT RJ-45 connector on the TP-121EDID to the
LINE IN RJ-45 connector on the TP-122, via CAT 5 cabling (with a range
of more than 300ft (>100m)), see section 8.
4. Connect the 12V DC power adapter to the power socket and connect the
adapter to the mains electricity on both
The signal from the XGA source is transmitted via CAT 5 cable, decoded and
converted at the XGA OUT 15-pin HD (F) connector to the XGA acceptor.
5. On the TP-122:

Adjust
equalization level, if required

If necessary, set the H SYNC and V SYNC switches
1 Download up-to-date Kramer user manuals from our Web site at
2 Not supplied. The complete list of Kramer cables is on our Web site at
3 If you cannot connect the power to both the TP-121EDID and TP-122, you can just connect the power to the TP-122
4 Use a screwdriver to carefully rotate the trimmer, adjusting the appropriate level
5 By default, both switches are set down (for negative V SYNC and H SYNC polarity)
6
Your TP-121EDID XGA / Audio Line Transmitter
2
. Alternatively, you can connect an XGA source to the
4
the video output signal level and/or cable compensation
Figure 2 illustrates, do the
3
the TP-121EDID and the TP-122.
http://www.kramerelectronics.com
http://www.kramerelectronics.com
KRAMER: SIMPLE CREATIVE TECHNOLOGY
9.
5
, on the underside