Bowflex TreadClimber TC10 Owner's Manual page 34

Maintenance
this procedure to apply an anti-static spray to them to reduce the static electric charges.
Wait a minimum of 60 minutes after the last workout before you apply the anti-static spray, to let hot
electrical components cool to room temperature.
1. Unplug the machine from the wall.
the power cord from the wall outlet and/or the machine and wait 5 minutes before cleaning, maintaining or
repairing the machine. Place the power cord in a secure location.
2. Using a 5 mm hex wrench, loosen the tension adjustment bolts for the walking belts to let them slide easily.
Turn the bolts counterclockwise to decrease the tension.
Note: Be sure to record how many turns it takes to loosen the bolts to assist with reassembly.
3. Carefully apply the anti-static spray to lightly cover the top surface of the walking belts along the front of the 3. Carefully apply the anti-static spray to lightly cover the top surface of the walking belts along the front of the
machine, farthest from the motor (green highlighted area). machine, farthest from the motor (green highlighted area).
NOTICE: Hold the spray dispenser approximately 6" (13 Hold the spray dispenser approximately 6" (13
cm) above the walking belt and point the spray toward the cm) above the walking belt and point the spray toward the
front of the machine, away from the motor. Apply the spray front of the machine, away from the motor. Apply the spray
only on the belts, not on the deck or mechanism. If spray only on the belts, not on the deck or mechanism. If spray
goes off the belts, wipe the excess spray off the other parts goes off the belts, wipe the excess spray off the other parts
of the machine.
Note: Be sure to obey the manufacturer safety
4. Using your foot, manually advance the walking belts 4. Using your foot, manually advance the walking belts
toward the back of the machine, exposing the next toward the back of the machine, exposing the next
unsprayed section.
5. Do steps 3 and 4 again until all sections of the belts are 5. Do steps 3 and 4 again until all sections of the belts are
lightly coated with anti-static spray.
6. Wait until the belts dry fully (approximately 2-4 hours). 6. Wait until the belts dry fully (approximately 2-4 hours).
7. Using a 5 mm hex wrench, tighten the tension adjustment bolts for the walking belts. Turn the bolts clockwise to 7. Using a 5 mm hex wrench, tighten the tension adjustment bolts for the walking belts. Turn the bolts clockwise to
34
To reduce the risk of electrical shock or unsupervised usage of the equipment, always unplug
Be sure to obey the manufacturer safety
instructions for the anti-static product. instructions for the anti-static product.