Connecting The Power Cord - Fujitsu PrintPartner 12V User Manual

Setting Up
1-12
Caution:
If the paper guide is not in the locked position, the printer will not
work.

Connecting the Power Cord

This printer comes equipped with one of the two voltage ratings:
VAC (such as for the USA)
120
to 240 VAC (such as for Europe)
220
The manufacturer' s nameplate on the back of the printer indicates
this rating. Confirm that the rated voltage of your printer matches
the voltage of your power outlet.
7. Remove the adhesive tape
which secures the rear
stacker. Open the rear
stacker and make sure the
paper guide is pushed down
in the locked position.
Close the rear stacker.
Check that the printer is
t u r n e d o f f . T h e '0 "-
marked side of the switch
should be depressed.
Plug the female end of the
power cord into the
connector on the left back
of the printer.
User´s Manual