Installing An Interface Expansion Board - Fujitsu PrintPartner 12V User Manual

Installing an Interface Expansion Board

Installing an
Interface
Expansion Board
3-4
2. Insert the emulation card into the bottom
3. Reinstall the RAM cards.
With default settings, the printer automatically selects the active
emulation. To specify an emulation steadily, select the emulation
using the control panel. Use the Personality item of the Config
menu.
Once you select the alternate emulation, the other menus change to
reflect the options and functions of the new emulation. Consult the
documentation supplied with the emulation card for the menu
functions and items. Procedures for working in the menus remain
the same as for the resident emulation.
The printer' s standard interfaces are paralle1 (Centronics xl) and
serial (RS-232Cxl). The currently available optional interfaces are
LocalTalk, Ethernet, Centronics, and IrDA. If your computer cannot
use a parallel port for your printer or the location of your printer is
distant from the computer,-you can use the LocalTalk port or
Ethernet port of the computer to connect your printer.Fujitsu offers
the ontional LocalTalk board and Ethernet board C or D for these
purposes The oprional Centronics board is offered, so that you can
use your printer-with two computers, using for both a Centronics
parallel interface, without disconnecting any of them. The IrDA
board is an infrared interface adapter.
Important:
When sharing the printer among multiple computers, setting the I/O
time-out short may cause a printing problem.
black
connector.
Use the bottom
black connector
User´s Manual