Table of Contents
Advertisement
3.
Place the horn assembly face down on a work bench and remove the four fixing
screws holding the 6.5" driver in place.
4.
The HF driver can now be accessed for replacement or to replace the diaphragm.
5.
Reinstatement of the high-mid driver is simply a reversal of the above procedure.
Make sure to observe the correct polarity when connecting the replacement driver.
Tighten all screws down firmly but do not over-tighten.
Use of thread locking compounds
The flygear on the rear of the cabinet should be inspected regularly, and all bolts should be
tightened where necessary. It is advisable to use thread-locking compounds on these fixings
in order to avoid any long-term possibility of loosening.
The recommended thread-locking compound is Loctite 222. The corresponding activator,
Loctite 7471, should be used to achieve 100% performance.
Application: Spray Loctite 7471 into the thread holes and allow to evaporate. Apply Loctite
222 thread locking compound to the bolts prior to fitting, allowing sufficient to fill all the
engaged threads. Assemble components and tighten as necessary.
user manual
FLEX ARRAY
FLEX ARRAY user manual
Page 75
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Flex Array TFA-600H and is the answer not in the manual?