Oce 3275 User Manual page 327

Troubleshooting
Copying Hints (continued)
COPYING DOES NOT BEGIN AFTER PRESSING START
Insert or adjust the appropriate paper tray for copy size selected.
Close document cover firmly.
Close front door completely.
Check to see if the message "Please close stacker cover of Trimmer" is displayed.
Close trimmer stacker cover completely.
COPYING DOES NOT RESUME AFTER MISHANDLED PAPER IS REMOVED
Check copier diagram on touch screen for additional indications of mishandled paper.
COPY QUALITY IS POOR
Check paper for dampness, and replace it if necessary.
THE ORIGINAL PAPER IS MISHANDLED OR SKEWED IN THE DOCUMENT FEEDER
Originals should conform to the recommended size and weight.
Be sure originals are not stapled.
Align originals evenly in the RADF.
Check to make sure paper guides meet the width of mixed size originals.
COPY IMAGE IS SKEWED WHEN BYPASS IS USED
Be sure copy paper is inserted straight.
USING ECM, COPIES CANNOT BE MADE AFTER PASSWORD IS ENTERED
Check to see if the message EXCEEDS LIMIT is displayed.
Contact key operator to reset limit.
FINISHER DOES NOT OPERATE
Press key.
OUTPUT APPLI.
Check for a paper misfeed and remove it, as required. Properly close finisher door.
RADF INDICATOR WILL NOT LIGHT AFTER AUTO/RESET IS PRESSED
Fully close RADF.
RADF LIGHT IS FLASHING
The document feeder is ready to accept originals.
Insert originals on RADF tray, press [ ], then [ ].
AUTO RESET START
ADD TONER MESSAGE IS DISPLAYED
New toner supply is needed. Follow instructions for adding toner.
Troubleshooting 16-9