Oce 3275 User Manual page 310

Maintenance & Supplies
Loading Paper (continued)
Loading Tabbed Sheets in Large Capacity Input (8.5x11, 11x17)
Load offset tabbed sheets so that the tab extensions are on the right at the rear (not
front) of the tray. The tab extension width should be 0.5" (12.5 mm) or less.
When loading tabbed sheets in the tray, be sure to specify the paper type as TAB in the
Key operator mode; otherwise mishandled paper may occur. See p. 14-24 to p. 14-25.
The top sheet is designated face up as the first tab of the finished set. Subsequent offset
tab sheets follow in sequence.
Rear
Front
Rear
Front
15-6 Maintenance & Supplies
Example (LT-401): 3 Tabbed sheets loaded in position for one finished set.
1st TAB
Section 1
Introduction
Printed
side
Example (LT-401): 9 Tabbed sheets loaded in position for 3 finished sets.
1st TABS
2nd TABS
3rd TABS
Section 1
Introducttion
Printed
side
Section 1
Introduction
2nd TAB
3rd TAB
ONE FINISHED SET
1st TAB 2nd TAB
Section 1 Section 1
Introduction Introduction
3rd TAB
3 FINISHED SETS
1st TAB
2nd TAB
3rd TAB
Section 1
Introduction