Aastra DT690 User Manual page 54

DT690
•
•
8.1.2 Text input Mode
•
•
•
•
8.1.3 Special characters
Use the keypad to enter letters and characters. Press a key once for the first
letter or character, twice for the second, three times for the third, and so on.
The most common letters are printed above each key on the phone. All the
available letters and characters are shown in Figure 15 on page 48.
, .? ! - ' " 1
g h i î ï 4
p q r s 7
Figure 15
Note: Depending on the selected menu language, other characters can be
48
Enter a pause in number input mode by a long press on
is indicated by a P in the display.
A long press on
indicated by a T in the display.
A short press on a key 0-9, displays the first available character on that
specific key. The marked character is selected after a time out, or when
another key is pressed.
To change to upper or lower case, press
character. The same key can also be used to display only digits.
To add space in the text, press 0.
A long press on
a b c æ à â ç 2
Space + * 0
Available characters
available. This means that the character order can differ from the figure
above.
changes the tone sender on. Tone sender on is
displays special characters.
d e f è é ê ë 3
j k l 5
m n o ñ ô ö œ 6
w x y z 9
t u v û 8
#
1424-EN/LZT 103 088 Uen A2 2008-11-21
. A pause
before entering the