Ac Power And Host Computer Connection - Bell and Howell Copiscan 8000 Spectrum Operator's Manual

4.2.1 How to Reorder Scanner All-In-One Consumable and Maintenance Kits
All-In-One consumable and Universal Maintenance Kits are available through Böwe Bell
+ Howell Authorized Service Providers (ASPs), Consumable Parts Resellers (CPRs) and
at www.bbhscanners.com. For a complete listing of ASPs and CPRs, please visit our
website at www.bbhscanners.com.
4.3

AC Power and Host Computer Connection

Once you have set up the scanner, you are ready to connect it to an AC power source and
to the host PC.
Take the following steps to connect the scanner to AC power:
1. Plug the female end of the power cord into the power receptacle on the rear of the
scanner.
NOTE:
You can plug the scanner into either a 100-120 VAC or 220-240 VAC outlet. The
scanner senses the voltage and automatically adjusts itself.
2. Connect the three-pronged male end of the power cord into a properly grounded,
three-hole AC outlet.
Take the following steps to connect the scanner to the host computer:
1. Connect the interface cable supplied with the scanner to the connector on the back of
the scanner. Secure the screws.
www.bbhscanners.com
1-800-SCAN-494 Sales
1-800-SCAN-495 Technical Support
Copiscan 8000 Spectrum Operator Manual
Figure 10. Power Cord Receptacle
17